Samsung OfficeServ 7000 Series Programming Manual page 183

No Option
6 CLIR w NUMB
8 ECT SERVICE
10 EFWD REROUT
11 SAME CONNID
13 CD PLAN
14 CD TYPE
15 TIME SYNC
16 DIVERT
17 CENTREX
© SAMSUNG Electronics Co., Ltd.
OfficeServ 7000 Series Call Server Programming Manual
When this option is set to ON, CLIP numbers are transmitted to the
network even though CLIP Restriction is set.
0. OFF
1. ON
Specifies the ISDN explicit call transfer option as follows:
0. NONE
1. REQ
2. RCV
3. BOTH
(This option may not be available in certain OfficeServ system.)
If the option is set to ON, the rerouting message can be sent as
FACILITY type.
When this option is set to OFF, ISDN port is searched by CONN ID and
if set to ON, searched by data channel id.
Specifies the called party's numbering plan as follows:
0. UNKNOWN
1. ISDN
2. NATION
Specifies the calling party's number type as follows:
0. UNKNOWN
1. INT. NAT
2. NATIONAL
3. NETWORK
4. SUBSCRIB
5. ABBREV
6. EXTEN
Determines the automatic update of the system time by the use of ISDN
Calls.
When this option is set to ON, the system time is updated if a correct
time value is transmitted from the trunk line.
In case of using MOBEX trunk, specifies partial rerouting message type
as follows:
0. OFF: Rerouting message can't be sent.
1. ON: Both diverting and original called number can be sent
2. EXCEPT CD: Only diverting number can be sent.
When ISDN trunk has centrex feature, MMC 210 ISDN PROGCON is
set to OFF and the 2nd progress message is incoming, dialed digit can
be sent as ISDN message type.
If the option is set to OFF, dialed digit is sent as DTMF type.
Description
(Continued)
2-145