Honda TRX680FA2011 Owner's Manual page 128

9. Pour the drained oil into a suitable container and dispose of it in an
approved manner (page
Improper disposal of drained f luids is harmf ul to the environment.
Add Engine Oil:
10. Check that the drain plug sealing washer ( ) and O-ring ( ) are in
good condition. If necessary, replace them.
(6)
(7)
(6) drain plug sealing washer
11. Apply a thin coat of engine oil to the O-ring.
12. Reinstall the engine oil drain plug and tighten it to the specified
torque:
18 lbf·ft (25 N·m , 2.5 kgf·m)
13. Fill the crankcase with the recommended grade oil approximately:
3.1 US qt (2.9 )
14. Reinstall the oil fill cap.
15. Start the engine and let it idle for 5 minutes.
16. Stop the engine and after 2 3 minutes, check the oil level. Make
sure the oil is between the upper and lower level marks on the dipstick.
If necessary, add more oil but do not overfill.
17. Reinstall the oil fill cap and dipstick.
18. Check that there are no oil leaks.
If a torque wrench is not used for installation, see your Honda dealer as
soon as possible to verify proper assembly.
Engine Oil & Filter
180 ).
−
6
(7) O-ring
Servicing Your Honda
7
121