Adjustment And Maintenance In Ptt Parameter Mode; Ptt Parameter Mode Operation Procedures - Canon MX882 Service Manual

MX880 series --- 3. ADJUSTMENT / SETTINGS

3-4. Adjustment and Maintenance in PTT Parameter Mode

Enter the PTT parameter mode in the user mode as below. (The PTT parameter mode cannot be entered in the
service mode.)
1) In the user mode, press the SCAN button to enter the scan mode.
2-a) Press #, 9, 7, 6, 9, # to enter the PTT parameter mode.
2-b) Press #, 9, 7, 6, 8, # to print the PTT parameter setting value.
How to finalize the data: Press the OK button to finalize the data, then press the Stop button to save the data.
How to exit the PTT parameter mode: Press the ON button to write the saved data to the EEPROM and turn
off the machine.
<PTT parameter mode operation procedures>
1. In the user mode, press the SCAN button to enter the scan mode and press #, 9, 7, 6, 9, #.
2. The following message is displayed on the LCD.
PTT PRAMETER
#1 BIT SWITCH
BIT SWITCH menu
3. Each time the right or left cursor button is pressed, the menu is changed.
PTT PRAMETER
#2 NUMERIC
PARAM.
NUMERIC PARAM. menu
PTT PRAMETER
#3 FAX TYPE
Note: Not used in servicing.
PTT PRAMETER
#4 NCU
Note: Not used in servicing.
PTT PRAMETER
#5 PTT SPECIAL
Note: Not used in servicing.
PTT PRAMETER
#6 FAX TEST
Note: Not used in servicing.
4. Press the OK button when "#BIT SWITCH" or "#2 NUMERIC PARAM." is displayed to enter either of those
modes.
59 / 76
TABLE OF CONTENTS