Canon MX882 Service Manual page 12

Ink tank not [1750] U141 Appropriate ink tank
recognized.
Ink tank not [1682] U150 The following ink
recognized.
No ink (no raw [1688] U163 The ink has run out.
ink).
Non-supported [2002]
hub.
Document [2800]
feeder cover not
closed.
Paper jam in [2801]
the ADF.
No paper in the [2802]
ADF.
Paper in the [2803]
(Applicable ink tank
icon)
is not installed. Install
the appropriate ink
tank.
tank cannot be
recognized.
(Applicable ink tank
icon)
Replace the ink tank.
(Applicable ink tank
icon)
--- An unsupported USB
hub is connected.
Remove the hub.
--- The feeder cover is
open. Close cover and
press [OK].
--- Document in ADF.
Check document in
ADF, then press [OK]
and redo operation.
--- No document in ADF.
Press [OK], then load
document and redo
operation.
--- Document size is too
the supported ink tanks.
A non-supported ink tank
is installed (the ink tank
LED is turned off). Install
the supported ink tanks.
A hardware error occurred
in an ink tank (the ink tank
LED is turned off).
Replace the ink tank(s).
Replace the empty ink tank
(s), and close the scanning
unit (cover).
Printing with an empty ink
tank can damage the
machine.
To continue printing
without replacing the ink
tank(s), press the Stop
button for 5 sec. or longer
to disable the function to
detect the remaining ink
amount. After the
operation, it is recorded in
the machine that the
function to detect the
remaining ink amount was
disabled.
Remove the applicable
USB hub from the
PictBridge (USB)
connector.
Close the document feeder
cover, and press the OK
button.
Remove the paper from the
ADF, and press the OK
button.
Press the OK button to
clear the error.
Remove the paper from the - DF unit
7 / 76
- Ink tank
- Ink tank
- Ink tank
- Spur unit
- DF unit
- DF switch unit
- DF unit
- DF unit