LG SIGNATURE LUWM101HWA Owner's Manual page 56

56 TROUBLESHOOTING
Error Code
The tub does not
rotate or
The door is not secured.
[dE],[dE1],[dE2]
Door sensor has
[dE4]
malfunctioned.
Drain hose is kinked, pinched,
Water in the washer
or clogged
drains slowly or not
at all and
Drain discharge is more
than 96 inches (2.4 m) above
[OE]
bottom of washer.
[tE] Control error.
Water level is too high due to a
[FE]
faulty water valve.
The water level sensor is not
[PE]
working correctly.
[LE] A motor error has occurred.
[LE1] Overload in fan-motor.
[LE2] Overload in compressor.
The water level too low or high
[PF] compared with the size of the
load.
Inlet hose, drain hose or drain
[FF]
pump frozen.
[dHE] Does not dry.
Possible Cause
Close and secure the door. If the message keeps
appearing, unplug the power cord and call for service.
Make sure the drain hose is free of clogs, inks, etc., and
is not pinched behind or under the washer.
Use the drain 96 inches (2.4 m) above the bottom of the
washer.
Unplug the washer and wait 60 seconds. Reconnect
power and try again. If the error reappears, call for
service.
Close the water faucets, unplug the washer, and call for
service.
Close the water faucets, unplug the washer, and call for
service.
Allow the washer to stand for 30 minutes and then restart
the cycle. If the LE error code persists, call for service.
Do not add more than the manufacturer's recommended
amount of detergent.
See the Care in Cold Climates section for instructions.
Call for service.
Solutions