LG SIGNATURE LUWM101HWA Owner's Manual page 51

Operation
Problem
Inlet hose connection is loose
at faucet or washer.
House drain pipes are clogged.
Water leaking
Drain hose has come out of
drain or is not inserted far
enough.
A large item such as a pillow
or blanket is above the top of
the tub.
Water leaks every
Hoses not installed correctly.
load
Kinked drain hose.
Washer will not
drain water
Drain located unproperly.
Power cord is not properly
plugged in.
Washer will not turn
House fuse is blown, circuit
on
breaker has tripped, or power
outage has occurred.
The washer automatically
adjusts the wash time for
Wash cycle time is
the amount of laundry, water
longer than usual
pressure and other operating
conditions.
Possible Cause
Check hoses for leaks, cracks and splits.
Check and tighten hose connections.
The washer pumps out water very rapidly. Check for
water backing up out of the drain pipe during drain. If
water is seen coming out of the drain, check for proper
drain hose installation and check for restrictions in the
drain. Contact a plumber to repair drain pipe.
Tie drain hose to inlet hose or standpipe to prevent it
from coming out during drain. For smaller drain pipes,
insert the drain hose into the pipe as far as the drain
hose flange. For larger drain pipes, insert the drain hose
into the pipe 1-2 inches past the flange.
Use the Bulky cycle for large or bulky items. Use extra
care and never wash more than half a load of items that
float, such as pillows.
Stop the washer and check the load. Make sure the load
does not crest above the top edge of the tub.
Normal Operation
Ensure that the drain hose is not kinked.
Make sure that the drain hose is no more than 5 ft. away
from the washer.
Make sure that the plug is plugged securely into a
grounded, 3-prong, 120 VAC, 60 Hz outlet.
Reset circuit breaker or replace fuse. Do not increase
fuse capacity. If the problem is a circuit overload, have it
corrected by a qualified electrician.
This is normal. The washer adjusts cycle time
automatically to provide optimal results for the selected
cycle. The time remaining shown in the display is only an
estimate. Actual time may vary.
TROUBLESHOOTING
Solutions
51