LG SIGNATURE LUWM101HWA Owner's Manual page 53

Problem
Filter clogged.
Inlet hoses may be kinked.
Energy efficiency.
Washer not filling
properly
Insufficient water supply.
The washer door is open.
Water level is too
low/ No water is Energy efficiency
visible in the drum
Too much detergent or
unsuitable detergent may
Oversudsing cause excessive foaming
which may result in water
leaks.
Buttons do not Buttons are disabled when the
function properly door is open.
A shortage alert
The machine is not level.
appears even
after you filled the
Reservoirs were refilled before
dispensers for
the shortage notification was
the detergent and
sent.
softener.
Water is not properly supplied.
The water is used for auto-
cleaning of lint-filter on drum
during the drying.
Drying performance
Water does not properly drain.
is poor.
The appliance is overloaded.
The spin speed is too low.
Possible Cause
Make sure the inlet filters on the fill valves are not
clogged. Refer to the filter cleaning instructions.
Check that inlet hoses are not kinked or clogged.
This is a High-Efficiency (HE) washer. As a result, the
water level settings for this washer may be different than
for conventional washers.
Make sure that both hot and cold water faucets are
turned on all the way.
The washer will not operate if the door is open. Close the
door and make sure that nothing is caught in the door
seal area preventing it from closing completely.
This is a High-Efficiency (HE) washer. As a result, the
water level settings for this washer may be different than
on your previous washer. The water will not normally
cover the clothes. The fill level is optimized for the wash
motion to achieve the best wash performance.
If using the Auto Detergent function, change the
dispense amount in the Settings menu under More
Settings. See the Auto Dispense section for more
information.
Clean the Auto Dispense tray and make sure to use an
HE detergent.
Do not put detergent in the manual dispenser while the
Auto Detergent function is turned on.
Press again after closing the door.
Make sure that the machine is level and all four feet rest
firmly on the ground.
The washing machine detects and sends shortage
notifications at the end of the wash cycle.
Make sure the water supply tap is open.
Make sure the drain filter is not clogged.
Check the load capacity for the selected cycle. If
necessary, add a Time Dry cycle.
Select the highest spin speed allowed for the wash cycle.
TROUBLESHOOTING
Solutions
53