JVC EX-D11J Service Manual page 13

3.1.12 Removing the DVD mechanism assembly
(See Figs.21 to 23)
• Remove the side panels L/R, top panel assembly, front panel
assembly, tuner, rear panel, switching power supply, digital
amplifier board assembly, micom board and regulator board.
(1) From the right side of the main body, remove the screw T
attaching the metal chassis. (See Fig.21.)
(2) From the top side of the main body, remove the screw U
and take out the metal chassis. (See Fig.22.)
Reference:
When attaching the metal chassis, pass the card wire
through the hole t on the metal chassis as before.
(3) Disconnect the card wire from the connector
video board. (See Fig.23.)
(4) Remove the three screws V and take out the DVD mecha-
nism assembly from the bottom chassis. (See Fig.23.)
CN703 on the
Metal chassis
Fig.21
Metal chassis
t
Fig.22
DVD mechanism assembly
V
V
CN703
Fig.23
U
V
Video board
(No.MB544)1-13