JVC EX-D11J Service Manual page 11

3.1.8 Removing the digital amplifier board
(See Figs.13 to 18)
• Remove the side panels L/R, top panel assembly, rear panel,
switching power supply and digital amplifier board assembly.
(1) From the forward side of the digital amplifier board assem-
bly, remove the screw M. (See Fig.13.)
(2) From the top and bottom sides of the digital amplifier board
assembly, remove the three screws N. (See Figs.14 and
15.)
(3) Release the joints (h, j, k, m) and remove the shield case
B with the heat sink in the direction of the arrow. (See
Figs.14 to 17.)
(4) From the forward side of the digital amplifier board, remove
the screw N attaching the heat sink. (See Fig.18.)
(5) Remove the solders from the soldered sections (n, p) and
bend the sections (q, r) of the shield case A in the direction
of the arrow. (See Fig.18.)
(6) Take out the digital amplifier board from the shield case A.
M
h
Heat sink
N
Shield case B
j
Digital amplifier board
Fig.13
Digital amplifier board
N
Shield case B
Fig.14
N
Digital amplifier board
Fig.15
k
Fig.16
Shield case B
m
Fig.17
q
N
n
Shield case A
Heat sink
Digital amplifier board
Fig.18
Shield case B
r
p
(No.MB544)1-11