Section 3
3.1 Setting password
In order to make changes to the NC machine data, the corresponding
password must be set. Certain machine data can only be changed with the
SERVICE or MANUFACTURER password, in this case, contact the builder
of the machine.
The following sequence shows graphically how to change/activate the
password.
Section 4
4.1 Changing machine data + data save
When the necessary password is activated the machine data can be
changed.
Machine data's are each having an activation criteria, this criteria deter-
mines when the new machine data value will become active. This criteria
is written in the machine data list next to the respective data.
Po
= after powering on
Re
= after pressing Reset key on machine control panel
Cf
= after powering on
Im
= immediately
After making changes to the machine data, it is important to make a
new backup see hand book module's C19 and C17
SINUMERIK 802D sl Operating and Service Training Manual
Setting password
Enter new
password
level
Change stan-
dard password
Password cancelled
Keyswitch active
Changing machine data + data save
Page 3
Notes
C41
C41