Principle Of Operation Rcs802; Rs232C Online Connection - Siemens SINUMERIK 802D Training Manual

Section 2 Principle of operation
Notes

2.1 Principle of operation RCS802:

RCS — Remote Control System for the 802D SL CNC Controller.
The RCS802 tool works on the principle of creating a permanent online
connection to the CNC controller. This permanent connection can be
RS232C or Ethernet.
To connect using RS232C the controller and the connected PC should
have the same configuration settings, Baud rate, stop bits etc.
To connect using Ethernet the controller and connected PC should have
compatible IP addresses.
This online connection permits a data transfer possibility over a long period
of time without a disruption in the transfer of data.

RS232C online connection:

The following sequence of operations should be carried out to obtain an
online serial connection to the controller:
1) Start RCS 802
Click to start
RCS 802
application
The following screen can be seen:
Activate online con-
nection on/off toggle
Connection
type
Explorer
Settings and
type window
connection
status
C1
C1
SINUMERIK 802D sl Operating and Service Training Manual Page 2