Heating And Cooling Modes - Dyson pure hot + cool link Operating Manual

Heating and cooling modes

Appliance is in cooling mode
Press the blue cooling mode button to enter cooling mode.
The power button light will change from red to blue to
indicate that you have entered cooling mode.
To adjust the airflow speed use the airflow control button
or use auto mode for automatic control.
Appliance is in heating mode
Press the red thermostat control button until the digital display shows the target room temperature. The power button light will change
from blue to red to indicate that you have entered heating mode. The heating symbol will be red while heating and will change to
white when the target room temperature has been reached. Once the target room temperature has been reached, the appliance will
stop heating the air. If the room temperature falls below the target temperature, the appliance will start to heat again. The red circle
surrounding the power button remains on when the product is in heater mode. To adjust the airflow speed use the airflow control button
or use auto mode for automatic control.
Room heating to 23°C
Each time the heating mode is selected, it conducts a short calibration cycle. Airflow will be automatically controlled during this cycle.
Once the calibration cycle is complete, it will revert to the selected airflow speed.
6
On first use, the appliance will default to a temperature 3°C
higher than the detected room temperature. Thereafter, the
appliance will remember the last target temperature set.
Room heated to 23°C
or above