Connections - Panasonic TH-37PR10U Operating Instructions Manual

Connections

– AC cord fixing
Note:
Make sure that the AC cord is locked
on both the left and right sides.
– Cable fixing bands
Secure any excess cables with bands as required.
Pass the attached cable
fixing band through the
clip as shown in the
figure.
1
SLOT1
1
Plug the AC cord into
1
the display unit.
Plug the AC cord until
it clicks.
2
2
Fix the AC cord with
the clamper which is
attached to the unit.
To secure cables connected to Terminals, wrap the cable fixing band around them then
pass the pointed end through the locking block, as shown in the figure.
While ensuring there is sufficient slack in cables to minimize stress (especially
in the power cord), firmly bind all cables with the supplied fixing band.
To tighten:
Pull
2
SLOT2
Optional Terminal
Board Insert Slot
(covered)
AC cord connection (see page 12)
Close
Push until
t h e h o o k
clicks.
Open
2. Pull off.
1. Keep the
knob
pressed.
To loosen:
Push the catch
SLOT3
From EXTERNAL
monitor terminal on
Computer (see page 10)
Unplug the AC cord
Unplug the AC cord pressing
the two knobs.
Note:
When disconnecting the AC
cord, be absolutely sure to
disconnect the AC cord plug
at the socket outlet first.
Pull
AUDIO
PC IN SERIAL
From SERIAL
Terminal on Computer
(see page 11)
9