Panasonic TH-37PR10U Operating Instructions Manual page 15

The remote control is not included with this set. Available for purchase separately.
Object model : EUR7636070R
Standby (ON / OFF) button
The Plasma Display must first be plugged into the wall outlet and turned on at the power switch (see page 12).
Press ON to turn the Plasma Display On, from Standby mode. Press OFF to turn the Plasma Display Off
to Standby mode.
ACTION button
Press to make
POSITION
selections.
buttons
SOUND button
(see page 24)
R button (see page 17)
Press the R button to return to previous menu screen.
Status button
Press the "Status" button to display the current system status.
PC
N ORM AL
OFF TIMER 90
SET UP button (see page 16, 17)
DIRECT INPUT buttons
Press the INPUT "1", "2", "3" or "PC" input mode selection button to
select the INPUT mode.
This button is used to switch directly to INPUT mode.
These buttons can only display the slot which is installed. If you press the button
whose slot is not installed, it automatically displays the current input signal.
When a dual input terminal board is attached, A or B is displayed
depending on the selected input signal. (Ex. INPUT1A, INPUT1B)
Note:
Image retention (image lag) may occur on the plasma display panel when
a still picture is kept on the panel for an extended period. The function that
darkens the screen slightly is activated to prevent image retention (see
page 42), this function is not the perfect solution to image retention.
Channel Adjustment
You can use this button when U/V Tuner Board with MATE I/F is installed
(optional accessories). Refer to each Board's Operating Instruction for detail.
Volume Adjustment
Press the Volume Up "+" or Down "–" button to increase or decrease
the sound volume level.
OFF TIMER button
The Plasma Display can be preset to switch to stand-by after a fixed
period. The setting changes to 30 minutes, 60 minutes, 90 minutes and
0 minutes (off timer cancelled) each time the button is pressed.
30
When three minutes remain, "OFF TIMER 3" will flash.
The off timer is cancelled if a power interruption occurs.
Digital Zoom (see page 25)
Press to access
Digital Zoom.
This displays an enlargement of the designated part of the displayed
image.
Basic Controls
Input label
1
1
Aspect mode (see page 18)
2 2
Off timer
3
The off timer indicator is
displayed only when the off
3
timer has been set.
60 90
0
15