Specifications - Makita TD090D Instruction Manual

ENGLISH (Original instructions)
1-1. Button
1-2. Battery cartridge
2-1. Switch trigger
3-1. Lamp

SPECIFICATIONS

Capacities
No load speed (min
Impacts per minute
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for screw driving in wood, metal
and plastic.
Noise
The typical A-weighted
according to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Work mode : impact tightening of fasteners of the
maximum capacity of the tool
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the power
•
tool can differ from the declared emission value
depending on the ways in which the tool is used.
Explanation of general view
4-1. Reversing switch lever
6-1. Bit
6-2. Sleeve
7-1. Bit
Model
Machine screw
Standard bolt
High tensile bolt
-1
)
Overall length
Net weight
Rated voltage
noise level determined
) : 92 dB (A)
pA
) : 103 dB (A)
WA
value (tri-axial vector
2
) : 10.0 m/s
h
2
ENE033-1
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
ENG905-1
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
For European countries only
EC Declaration of Conformity
Makita declares that the following Machine(s):
Designation of Machine:
Cordless Impact Driver
Model No./ Type: TD090D
ENG900-1
Conforms to the following European Directives:
2006/42/EC
sum)
They are manufactured in accordance with the following
Standard or standardized documents:
EN60745
The Technical file in accordance with 2006/42/EC is
available from:
Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium
ENG901-1
000331
Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium
3
7-2. Bit-piece
7-3. Sleeve
TD090D
4 mm - 8 mm
5 mm - 14 mm
5 mm - 10 mm
0 - 2,400
0 - 3,000
155 mm
0.92 kg
D.C. 10.8 V
31.12.2013
Yasushi Fukaya
Director
ENH101-17