CHAPTER 15
The e-mail send/receive function enables the CPU module to send e-mail to and receive it from electronic devices
such as mobile phones and personal computers.
(1) Sending and receiving e-mail
(a) Sending e-mail
After setting the send destination e-mail address, the e-mail send instruction (SP.MLSEND) is executed to send
e-mail during END processing.
(b) Receiving e-mail
The e-mail receive instruction (SP.MLRECV) is executed to get e-mail stored in the server to the CPU module.
The "Subject + message body" of e-mail is written to the specified device.
(2) Function to read/write device when e-mail is received
Writing an MC protocol command in the message body of e-mail sent to the CPU module from a personal
computer or mobile phone enables device reading or writing.
After command execution, e-mail is returned to the send address to report the execution result. (
Section 15.3.1)
(3) Send destination e-mail address edit function
This function enables a remote mobile phone or personal computer to change the send destination e-mail
address. (
Remark
When using the e-mail send/receive function, check the versions of the CPU module and GX Works2. (
Appendix 3)
E-MAIL SEND/RECEIVE FUNCTION
Sending e-mail
Receiving e-mail
Page 203, Section 15.3.2)
CHAPTER 15 E-MAIL SEND/RECEIVE FUNCTION
Personal computer
Mail server
Ethernet
Mobile phone
15
Page 199,
Page 222,
193