Requirements For Roll Paper - Epson TM-L90 Manufacturing Manual

Confidential

1. REQUIREMENTS FOR ROLL PAPER

This printer can use receipt roll paper and label roll paper with the following roll paper
specifications:
Paper type
Form
Paper width (backing
paper width)
Take-up roll paper width
Roll paper spool
diameter (inside)
Roll direction
Roll end position
Outside diameter
(*) Using roll paper with an inside diameter of 25.4 mm {1"} or less may decrease the
detection accuracy of the roll paper near-end sensor.
Thermal paper
•
Receipt paper
•
Die-cut label paper
•
Continuous label paper
Roll paper
79.5 ± 0.5 mm {3.13 ± 0.02"}
•
37.5 ± 0.5 mm ~ 69.5 ± 0.5 mm
•
{1.48 ± 0.02 ~ 2.74 ± 0.02"}
•
80 +0.5/–1.0 mm {3.15 + 0.02/-0.04"}
•
38 ~ 70 mm +0.5/–1.0 mm {1.5 ~ 2.76 +0.02/-0.04"}
25.4 mm {1"} or more (*)
Printed side must face outside.
Be sure that roll paper does not have any cuts or tears at
any place in the roll.
Paper must not be pasted to the roll paper spool.
Outside roll paper diameter: Maximum 90 mm {3.54"}
TITLE
TM-L90
Roll Paper
Manufacturing Guide
SHEET NO.
REVISION
A NEXT
2
SHEET
1