Requirements For Size Of Continuous Label Paper - Epson TM-L90 Manufacturing Manual

Tm-l90 series
Hide thumbs Also See for TM-L90:
Table of Contents

Advertisement

Confidential

4.4 Requirements for Size of Continuous Label Paper

To make a cut-off edge, be sure to manufacture label paper that meets the requirements in the
figure below:
Note: "cut-off edge" is a method of cutting and removing the edge of the label in advance so that
the label can be peeled off easily from the backing paper.
Requirements for Size of Label Paper of the Cut-Off Edge Type
NOTES: *1. When performing a full-cut, for the cut-off edge (a): 3.5 mm {0.14"} or more is not
necessary; however, even though it is not necessary, it is recommended that
cut-off edges with approximately 2 mm {0.79"} width be provided for (a) and (b) so
that the label can be peeled off easily from the backing paper.
*2. When using a label with 80 mm {3.15"} paper width, the cut-off edge (b) is not
necessary. However, when labels with a width between 38 ~ 70 mm {1.5 ~ 2.76"}
are used, be sure to make the cut-off edge (b): 0.3 mm {0.12"} or more to prevent
the adhesive agent of the label roll paper from being attached to the platen.)
*1 cut-off edge (a):
3.5 mm {0.14"} or more
Face stock (printing side)
TITLE
TM-L90
Roll Paper
Manufacturing Guide
*2 cut-off edge (b):
0.3 mm {0.12"} or more
Paper feeding
direction
SHEET
REVISION
A
NO.
NEXT
SHEET
14
13

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents