Teac AI-503 Owner's Manual page 18

Bluetooth® wireless technology (continued)
Playback from a Bluetooth device
o Pair this unit the first time you use it and when you want to con-
nect it with a different Bluetooth device for the first time (page
17) .
o When pairing or connecting with another Bluetooth device,
they should be within a few meters of each other . If they are
too far apart, pairing and connection afterwards might become
impossible .
1
Turn the INPUT SELECTOR knob to select
(Bluetooth).
This sets the mode to Bluetooth .
o The Bluetooth indicator blinks and connection with other
Bluetooth devices becomes possible .
2
Enable Bluetooth transmission on the other
Bluetooth device.
When the input source of this unit is set to
Bluetooth device is on, the Bluetooth function will be active
and they will connect automatically .
If they do not connect automatically, however, you can connect
them manually .
o When is selected for this unit, the Bluetooth device that
was last connected to it will automatically be connected
again . If you want to connect with a different Bluetooth
device, conduct pairing with that device .
o If the Bluetooth indicator on this unit continues to blink for
30 minutes, it will automatically enter standby mode . To use
this unit, you must turn it on again .
ATTENTION
Regardless of the connection status of this unit and the other
Bluetooth device, if the Bluetooth indicator continues blinking
for a long time, restart both this unit and the other device and
then reconnect them .
3
Start playback on the other Bluetooth device.
Confirm that the volume is turned up on the other Bluetooth
device . If you do not turn up the volume on the playback
device, no sound might be output from this unit .
o Depending on the connected Bluetooth device, you might
not be able to adjust the volume . For details, refer to the
operation manual of that Bluetooth device .
18
4
Turn the VOLUME knob to adjust the volume.
o You can also do this with the VOLUME (+/−) buttons on the
remote control .
o If headphones are connected to this unit, audio will not be
output from the speaker (SPEAKERS) terminals or preamp
audio output (PRE OUT) connectors on the back of the unit .
and the other