Teac A-H01 Install Manual

Mac
Compatible products
A-H01, UD-H01, NP-H750, AI-501DA
System requirements
Mac with Intel processor
The following Mac OS versions are supported (as of January 2018)
Mac OS X (Snow Leopard) 10.6.4 or later
OS X Lion (10.7)
OS X Mountain Lion (10.8)
OS X Mavericks (10.9)
OS X Yosemite (10.10)
OS X El Capitan (10.11)
macOS Sierra (10.12)
macOS High Sierra (10.13)

Installing the driver

1
Go to the download page of your product on the TEAC Global
web site (https://teac.jp/jp/language), and download the Mac
Driver.
2
Unzip the downloaded file, then open "TEAC USB HS Audio
KEXT Install Package xxxxx.pkg" (xxxxx is the driver version) in
the extracted folder.
A warning window that says "TEAC USB HS Audio KEXT Install Package xxxx
Note
cannot be opened because it is from an unidentified developer." may appear.
If it appears, hold the Control key and right click, then choose "Open" from the
menu, and click "Open" to continue with the installation.
3
Follow the instructions to proceed with the installation.
Your user name and password will be required to proceed
with the installation.
The user name and password required in this step are those which you use
Note
when you start up or log in to the Mac.
TEAC USB HS Audio Driver Install Guide
4
Choose "Restart" when the installation completes.
In this step, the following message may appear.
If it appears, click "OK" to restart.
If you are installing the driver on a system that uses macOS High Sierra,
follow steps 5 to 7, otherwise, jump to step 8.
5
After restart, open "Security and Privacy" in System Preferences.
6
Click "Allow" in the "General" tab.
If "Allow" is disabled and grayed out, click the Lock icon [ ]
to allow the setting to be changed.
You can then enter the password you used in step 3.
If the blocked driver is TEAC USB HS Audio alone, it shows "Legacy
Developer: Teac".
This setting change MUST be carried out within 30 minutes
Important
of the driver being installed.
1