Polycom IP 5000 User Manual page 6

- Hostname or IP Address
- DNS SRV
Registering your device
A) Line configuration from devices web interface
To access web interface of your Polycom phone first you must now it's IP address on your
network.
You can find this information on your device under:
Press the Menu button.
Go to Status and press the Select button.
Go to Network and press the Select button.
Go to TCP/IP parameters and press the Select button.
After you enter TCP/IP parameters IP address should be displayed.
In your web browser enter IP address of your Phone, if everything is OK, you should be
displayed with Username and Password prompt. If your Polycom device is at factory defaults
Username should be Polycom (with capital P) and password should be 456.
NOTE: Depending on your Polycom device and its firmware, web interface settings may vary.
After you log in, under VIEWS you should select Simple Setup.
Then use the toggling show/hide button to reveal the content of the SIP Server group.
Next enter your PBXware IP address into Address field then put 5060 into Port.
After this has been completed you should then use the toggling show/hide button to reveal the
content of the SIP Line Identification and enter your line extension into the fields Address
and Authentication User ID.
Then for the Authentication Password you have to enter the secret for the extension which
can be found in your PBXware.
After all these fields are set to preferred values, click Save button to preserve your changes. If
everything is OK, your phone should register after reboot.
B) Line configuration on device
Press the Menu button on your phone.
Go to Settings and press Select button.
Go to Advanced and press Select button.
Enter password and press Enter button. Please note, factory default password is 456.
Press Select button to enter Admin Settings.
Go to Line Configuration and press Select button.
Go to Line 1 and press Select button.