Polycom IP 5000 User Manual page 11

configuration file. If everything is done as above described, you should have successfully
registered your phone to PBXware. Dial *123 to verify registration.
TFTP or HTTP & HTTPS
Network Configuration
If there is no DHCP in your network, you can still auto provision your Polycom phone. Please
refer to your Polycom phone model User Guide for instruction about setting static IP address.
After you configure your Polycom phone to use a static IP address, continue with the following
steps.
Press the Menu button on your phone.
Go to Settings and press the Select button.
Go to Advanced and press the Select button.
Enter password and press the Enter button. Please note, factory default password is 456.
Press the Select button to enter Admin Settings.
Press the Select button to enter Network Configuration.
Press the Select button to enter Provisioning Server.
Go to Server Type and press the Edit button.
You must choose one of the following Server Type: HTTP, HTTPS and Trivial FTP and press
the Ok button. Please Note:
Go to the ServerAddr and press the 'Edit button.
Depending on what Server Type has been chosen:
If the Server Type is HTTP or HTTPS enter http:// or https:// followed by
Hostname or IP Address, followed then by /prov and press the Ok button.
Example for Hostname using HTTP: http://abc.bicomsystems.com/prov
Example for Hostname using HTTPS: https://abc.bicomsystems.com/prov
Our reconmendation is to use the Server Type HTTP.