Oki MC363DN Configuration Manual page 62

34. On the Filter Action Wizard, click Next.
35. On the Filter Action Name screen, enter a Name and a Description and then click
Next.
36. On the Filter Action General Options screen, make sure that Negotiate security
is selected and then click Next.
37. On the Communicating with computers that do not support IPsec screen,
make sure that Do not allow unsecured communication. is selected and then
click Next.
38. On the IP Traffic Security screen, select Custom and then click Settings.
39. On the Custom Security Method Settings window, configure the settings and
then click OK.
NOTE
Select the same values specified in the configuration for "Phase2 Proposal" in
"Configuring your machine" on page
40. On the IP Traffic Security screen, click Next.
41. Select Edit properties and then click Finish.
42. On the filter action properties window, select Use session key perfect forward
secrecy (PFS) if you want to enable Key PFS.
43. Select Accept unsecured communication, but always respond using IPsec if
you perform IPSec communication by the IPv6 global address.
44. Click OK.
45. Select the new filter action and then click Next.
46. On the Authentication Method screen, select the value you want and then click
Next.
47. Click Finish.
48. On the IP security policy properties window, click OK.
49. On the Local Security Policy window, select the new IP security policy.
50. From the Action menu, select Assign.
51. Make sure that Policy Assigned for the new IP security policy is displayed as Yes.
52. Click X on the Local Security Policy screen.
60.
Advanced network settings > 62