Service Information; Jumper Setting On Hard Disk Drive - Sony PCV-RX640 Service Manual

4-1.

JUMPER SETTING ON HARD DISK DRIVE

The hard disk drive of service parts can be used without changing factory jumper setting, when it was replaced for service.
Part No.
A-8110-897-A
A-8025-545-A
A-8058-425-A
Part No.
A-8059-699-A
SECTION 4

SERVICE INFORMATION

Maker Code
Seagate ST340810A
Seagate ST360020A
Seagete ST380020A
7
8
Configuration Jumper Setting
Maker Code
Maxtor 4G120J6
Configuration Jumper Settings
4-1
(END)
Capacity
(formatted)
40 GB
60 GB
80 GB
1
2
Limit capacity
>32 Gbytes = 32 Gbytes
<32 Gbytes = 2.1 Gbytes
Master or single drive
Drive is a slave
Master with a non-ATA
compatible slave
Enable cable select
Capacity
(formatted)
120 GB
Master/Slave selection
Jumper setting
J42 Factory Reserved
J44 Factory Reserved
J46 Cylinder Limitation
J48 Cable Select
J50 Master/Slave
Only drive in single drive system
Master drive in dual drive system
Slave drive in dual drive system
Memo
Memo
Confidential
PCV-RX6__Series (AM)