Cannot Receive Any Incoming Calls; Ttl (Registration Interval); Faq; How Do I Access V431'S Web Interface - NetComm V431 Quick Start Manual

5.5

Cannot receive any incoming calls

If you cannot receive any incoming calls, please make sure you untick "Unconditional Forward"
in "Calling Features" tab. This function blocks every incoming call and forward all incoming
calls to the phone number you specify in configuration.
5.6

TTL (Registration interval)

MyNetFone default Value is "240", Please do not change it. Improver values will influence
successful rate of VoIP calls.

6 FAQ

6.1 How do I access V431's Web Interface?

Once you have connected your V431 and PC you will need to:
Open a web browser and type in V431's IP address (default IP is http://192.168.8.254)
Enter your User Name (default is admin)
Enter your Password (default is admin)
Note: If you forget the password or the IP address of V431, hold the reset button in for 10
seconds. This resets the router to factory default.

6.2 What's the QoS (Quality of Service) and how to set it?

Sets true bandwidth of your Internet connection to ensure sound quality during transmission.
(When this function is enabled, the voice packet has the highest priority to ensure
telecommunication quality while less bandwidth is assigned for data transmission). Some
models of the VoIP gateway without this function can adjust the bandwidth automatically.
NOTE:
The WAN QoS function only works as expected when you connect/configure the gateway
as described on Page 14. If the gateway is behind an Internet sharing device as described
in Page 15, QoS for VoIP traffic should be guaranteed by your network routers and not the
VoIP gateway.
ToS/DiffServ (Type of Service/DSCP): The voice packet has the highest priority to ensure
telecommunication quality; the larger the value you set, the higher priority you will get.
Please contact your ISP when you configure these values.

6.3 Call I transfer VoIP call to any other outside numbers?

No, V431 only supports transfer phone calls to other FXS ports internally.

6.4 Can I disable FXS Outbound CLI using MyNetFone service?

Please call MyNetFone Customer Support on 181 or 1300 731 048.

6.5 How does Call-hunting work?

Select group hunting when there is an incoming call and the gateway will automatically assign
an unassigned call according to the Hunting Priority. If Line 2 does not want to be set as an
assigned line to receive any inbound calls, the function can be disabled. Users can also use the
Up or Down key to adjust hunting priority (No setting is required for the FXO interface).

6.6 What's the Hot line and Warm line?

FXS port: When the user picks up the phone, the gateway automatically dials your assigned
hotline number. When in hotline mode, other phone numbers cannot be dialed.
FXO port: When receiving a call from an outside line, the gateway will divert the call to the
assigned hotline number.
Hot Line No.: Enter the hot line number for automatic dialing function.
Warm Line: When the Warm Line function is in use, user can dial a number. Otherwise the
system will divert incoming calls from an outside line to the Hot Line Number after a set wait
time.

6.7 How do I backup my current settings?

You can backup settings to a file and restore settings from that file. You also can restore all
settings back to default by selecting Restore Default Configurations and click Restore.
Your Broadband VoIP Phone Service
My Net Fone Ltd.
A.B.N. 37 118 699 853
12