Table of Contents
Advertisement
Preparing for Server Component Installation
Required Equipment
The following equipment is used to perform the procedures in this chapter:
•
•
Shutting Down and Powering Off the Server
The server can run in two power modes:
•
•
You can invoke a graceful shutdown or an hard shutdown by using either of the following methods:
•
•
Step 1
Check the color of the Power Status LED (see the
LEDs and Buttons" section on page
•
•
Step 2
Invoke either a graceful shutdown or a hard shutdown:
To avoid data loss or damage to your operating system, you should always invoke a graceful shutdown
Caution
of the operating system.
•
•
Step 3
Disconnect the power cords from the power supplies in your server to completely power off the server.
Cisco CSS UCS Platform Series User Guide, CPS-UCS-1RU-K9 / CPS-UCS-2RU-K9
4-2
Number 2 Phillips-head screwdriver
Electrostatic discharge (ESD) strap or other grounding equipment such as a grounded mat
Main power mode—Power is supplied to all server components and any operating system on your
drives can run.
Standby power mode—Power is supplied only to the service processor and the cooling fans and it
is safe to power off the server from this mode.
Use the CIMC management interface.
Use the Power button on the server front panel. To use the Power button, follow these steps:
Green—the server is in main power mode and must be shut down before it can be safely powered
off. Go to
Step
2.
Amber—the server is already in standby mode and can be safely powered off. Go to
Graceful shutdown—Press and release the Power button. The operating system performs a graceful
shutdown and the server goes to standby mode, which is indicated by an amber Power Status LED.
Emergency shutdown—Press and hold the Power button for 4 seconds to force the main power off
and immediately enter standby mode.
"Cisco Connected Safety and Security UCS C240
1-15).
Chapter 4
Replacing Hardware Components
Step
3.
Advertisement
Table of Contents
