6 Peeler commands
The following are the peeler commands. For details of each command, see the
separate Command Reference.
Peeling position designated command STX f, STX Kf
This command designates the feeding amount from the reference point to the peeling
position.
Software switch setting command STX V
The peeler function can be temporarily turned ON or OFF by transmitting this
command to the printer while turning on the power to the printer.
Note: If the label is at peeling position when the peeler function is selected, the
media will not feed even if the Feed key is pressed. In this case, remove the
label first.
I – 9