Peeler Setting; Peeler Door Opening/Closing; Media Loading - Citizen PEELER CL-E700 series User Manual

4 Peeler setting

4-1 Peeler door opening/closing

1 Opening
Shift the release knob of the peeler to the left with the finger, and the peeler door
will open.
2 Closing
Push down the left end of the peeler door until it clicks closed.

4-2 Media loading

1 First peel off the labels with a length of 12 cm (5 inch) or more on the top of the
loading media, then load the media into the peeler where the first label comes to
the peeling sensor. Close the print head of the printer.
2 Open the peeler door and pass the liner between the peeling roller and the peeler
door and close the door.
4-3 Peeler setting
To use this peeler, set the peeler function ON that is one of the various setting items in
a nonvolatile memory in the printer.
To change the setting of the peeler function, execute it in the printer configurations
setting mode from the control panel or use the command STX KD.
The CL-E700 series has the menu "AutoConfigure" set to ON when shipping from
the factory. In this ON condition, if the peeler is installed on the printer, the menu
"Function Select" will be automatically changed to "Peel On." But if the Off condition
occurs, select the "Peel On" in the following manner. (For details of menu setting,
refer to the operation manual of each printer.)
 Selecting the "Peel ON" in the menu setup mode
1 In a condition that the "Ready" is displayed on the control panel, press the MENU
key and the printer will be placed into the printer configuration setting mode.
2 Press the Feed key twice first and then the Stop key.
3 Press the Feed key and the menu "Function Select" will be displayed.
4 Press the Stop key and the current function select item will be displayed.
5 Press the Feed key 1-3 times until the "Peel On" is displayed.
6 Press the Stop key and the current contents will be stored in the memory.
If turn off the power, the printer will return to the original menu item. If the current
setting data is required to be stored permanently, perform the "Save Settings"
operation, referring to Chapter 2 in the User's Manual of the printer.
Note: After selecting the peeler function, feed the media to the peeling position
by pressing the Feed key. After this, the media, once printed, automatically
advances towards the peeling position and there the label is peeled off.
I – 7