Stihl MS 240 Instruction Manual page 79

: Ease the interlock lever (1) out of
its mounts (arrows).
– Disconnect the torsion spring and
remove the interlock lever.
2
: Use a drift (2) to drive out the pin
(1).
1
– Set the switch shaft to "
: Remove the throttle trigger (1)
with torsion spring (2).
78
1
1
2
– Check the interlock lever (1),
trottle trigger (2) and torsion
spring (1) and replace if
necessary
Versions with handle heating
1
Make sure the wires are properly
positioned in the guide (arrows).
2
1
0
".
: Attach the torsion spring (1) to
the throttle trigger (2)
– note installed position (arrow).
3
: Fit the throttle trigger (1) in the
: Use a drift (2) to line up the
: Drive home the pin (3) until it is
2
1
rear handle so that its lug is
behind the arm on the switch
shaft (arrow).
1
3
throttle trigger (1).
centered (recessed by same
amount at both sides).
MS 240, MS 260, MS 260 C
2