Use Your Tv; Switching On; Switching Off - Philips 32PFL5505/V7 User Manual

4

Use your TV

Switching on

Follow the instructions on this page on how to switch on your TV set and the remote
control before going on to following pages describing how to use the channel set-up
procedure.
HDMI IN 1
HDMI-1
Y
L L
R R
AUDIO/VIDEO IN COMPONENT / AUDIO/VIDEO

Switching off

To put the TV set into standby mode, press the button
but with low energy consumption.
To switch off the TV set,
8 EN
1. Insert two AAA batteries in the remote control.
Precautions on using batteries:
- Only use the battery types specified.
- Make sure you use the correct polarity.
- Do not mix new and used batteries.
- Do not use rechargeable batteries.
- Do not expose batteries to excessive heat such as sunshine, fire or the like,
throw them in a fire, recharge them or try to open them, as this could cause
them to leak or explode.
- Remove the batteries from the remote control if you are not using it for a long
period of time.
2. Connect the power cable to a mains socket.
Your TV set should only be connected to an AC supply. It must not be connected
to a DC supply. If the plug is detached from the cable, do not, under any
circumstances, connect it to a mains socket, as there is a risk of electric shock.
HDMI IN 1 HDMI IN 2
Y
ANTENNA
IN
L L L
R R R
COMPONENT AUDIO/VIDEO IN AUDIO/VIDEO OUT AV IN 1 VGA AUDIO /VIDEO IN
Note: The figures are for representation only. The location of the power socket at
the back of the television might differ depending on the model.
3. Connect the outside aerial or cable network to the ANTENNA IN socket at the
back of the TV set.
The aerial socket (75 OHM - VHF / UHF / cable) can be used for connecting
HDMI IN 1 HDMI IN 2
Y
an external aerial or other equipment fitted with a modulator (video recorder,
IN ANTENNA
L L L
R R R
COMPONENT AUDIO/VIDEO AV IN 1 VGA AUDIO
AUDIO/VIDEO IN OUT /VIDEO IN
satellite receiver, etc.). We recommend that you do not connect other equipment
(video recorder, satellite receiver, etc.) to your TV set to begin with, so as not to
complicate the set-up procedure with the additional steps involved. Connect
them when you have finished setting up the channels.
4. Switch the TV on by pressing the power button.
Note:
HDMI IN 2
HDMI-2
ANTENNA If the TV set is in standby mode, press the
IN
L
R
OUT / AV1 AV IN 1 /VIDEO IN VGA AUDIO VGA /
the CH+/- buttons on the remote control or at the side of the TV set to turn on
the TV.
press the power button
The location of the power button on the TV may vary according to TV model.
on the remote control. The TV set remains powered up,
.
button on the remote control or