Inserting The Battery Pack; Charging The Battery Pack; Cleaning Floors - Dirt Devil M612 Instruction Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 13

Inserting the battery pack

Firmly remove cover from battery compartment
1
(Fig.
/OPEN).
Insert the provided battery pack.
5
2
Ensure that the sticker with the words "This side up" is
facing up and the contacts in the battery compartment
are able to engage in the apertures in the insulation of
the battery pack. For this purpose, let the battery pack
first slide into the battery compartment on the side
with the contacts (Fig.
6
pack into the battery compartment on the other side
(Fig.
). The battery pack must rest evenly on the bot-
8
tom of the battery compartment.
er of the battery compartment and slide it firmly into
its bracket until you hear and feel it click into place.

Charging the battery pack

!
WARNING!
Risk of fire or explosion! Only use the mains
adapter included in the scope of supply to charge
the battery pack.
 Ensure that the ON/OFF switch is in position 0
1
(Fig.
/
).
Connect the plug of the mains adapter
11
B
2
cable to the charging socket on the appliance (Fig.
Connect the mains adapter to a socket (Fig.
3
➔ The charging indicator light (Fig.
blue to indicate the charging process.
imum of 4 hours, the charging indicator light remains
blue. ➔ The rechargeable battery is then charged.
Disconnect the mains adapter from the socket (to
5
save electricity) and disconnect the plug of the mains
adapter cable from the appliance.
NOTE:
Recharge the appliance when the battery indicator
(Fig.
1
/
) on the appliance lights up with constant
3
red light.
Setting the anti-fall sensors
Your robot vacuum cleaner automatically detects drop-
offs in front of it by means of 3 anti-fall sensors (Fig.
As a result, it changes its direction of travel and contin-
ues to clean in the opposite direction. Lower-level surfac-
es, such as stairs are detected and thus omitted from the
cleaning.
You can adjust the sensitivity of the anti-fall sensors
as follows:
WARNING!
!
Test the correct settings repeatedly while you are
present to avoid damage by incorrect settings.
) and then press the battery
Reattach the cov-
3
10
/
) lights up
1
1
After a max-
4
EN
Ensure that the ON/OFF switch is in position 0
1
(Fig.
/
).
11
B
2
trollers to set the sensitivity of the anti-fall sensors at
the bottom of the appliance (Fig.
• Position 0 (smallest opening) for light floors and
low steps
• Position 1 (Fig.
higher steps
• Position 2 for dark floors and even higher steps
• Position 3 (largest opening, Fig.
floors and high steps
NOTE:
All 3 slide controllers have to be set to the same
setting. If your robot constantly travels backward
on dark floors, you must select position 3 (largest
opening).

Cleaning floors

NOTE:
To clean short pile carpets, remove the round
brooms first. To do so, grab the bristles and firmly
pull the round brooms upwards (Fig.
Do not use the appliance on long pile carpets.
9
).
▶ 
To switch on the appliance, place it on the floor and
).
set the ON/OFF switch to position I (Fig.
➔ Both external LEDs flash alternately. After approx.
8 seconds the appliance will start to move in "random
mode" (Fig.
/
3
ance changes to "gyro mode", moving in ever increas-
ing circles (Fig.
counters an obstacle in this mode, it changes to "edge
mode" (Fig.
/
4
be cleaned for approx. 3 minutes. Then the cycle starts
all over again with "random mode" (Fig.
NOTE:
If the appliance has become stuck on an obstacle,
give it a gentle push with your hand.
NOTE:
2
).
When the performance of the battery pack dimin-
ishes, the battery indicator (Fig.
red and the appliance stops soon afterwards. If
this is the case, the appliance will beep every
60 seconds to make it easier to locate it. (If the
battery pack is completely flat, the beep function
will stop.) Then switch off the appliance and
charge the battery pack > "Charging the battery
pack" on page 17.
Adjust the position of the slide con-
/
):
1
12
/
) for light floors and slightly
12
B
/
12
A
13
11
). After approx. 3 minutes the appli-
A
3
/
). As soon as the appliance en-
B
), traversing the edges of the room to
A
4
/
1
3
17
) for dark
/
).
B
/
).
A
/
).
B
) remains

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Spider 2.0

Table of Contents