Philips 26HFL5561L/27 Quick Start Manual page 9

6 Configure SmartFeatures
settings
Configure SmartPower settings
Philips continuously focuses on lowering the environmental impact
of its consumer products by adopting energy efficient ways of power
management.
This section describes how to select a setting for maximum power
savings.
1
Press M on the setup remote control to display the setup menu.
2
to select CONFIGURATION > SMARTFEATURES.
Press
SMARTFEATURES
SMARTPOWER
AUTOSENSE
LOW POWER STANDBY
SMARTGUIDE CATEGORIES
USB BREAK-IN
SMARTUPDATE
SW DOWNLOAD
3
Press to select one of the following to configure the
settings:
• SMARTPOWER: Sets a power saving mode. Select one of the
following :
OFF: Rich and dynamic settings, ideal for daylight use.
•
Disables power savings.
LOW: A natural picture setting. Achieves low power savings.
•
MEDIUM: Ideal settings for watching movies. Achieves
•
medium power savings.
HIGH: Applies low-energy settings. Achieves highest
•
possible power savings.
AUTOSENSE: Reduces the TV's power consumption according
•
to the room's ambient light. Select YES to enable the TV's built-
in ambient light sensor.
LOW POWER STANDBY: Uses minimum power when the TV
•
is in standby mode.
Note
• If LOW POWER STANDBY is set to YES,
•
the TV can only be switched on with a remote control. Please ensure the
remote control is always available. The control buttons at the side of the
TV will not be able to switch on the TV.
•
If LOW POWER STANDBY is set to YES, the TV will be configured to
the optimal energy saving mode whenever the TV is switched to standby
mode. As a result, the TV will take a little longer to switch on again. If you
need a fast switch on time, select NO.
Configure SmartGuide Categories
This section provides information to configure SmartGuide Categories
icons. Guests can access these icons by pressing the CHANNEL
GUIDE button on the guest remote control to display the SmartGuide
Categories screen. Refer to the previous chapter for information to
assign TV channels to categories (see 'Select a ring' on page 4).
1
Press M on the setup remote control to display the setup menu.
2
Press
> SMARTGUIDE CATEGORIES.
SMARTPOWER
AUTOSENSE
LOW POWER STANDBY
SMARTGUIDE CATEGORIES
USB BREAK-IN
OFF
SMARTUPDATE
NO
SW DOWNLOAD
NO
>
NO
NO
>
3
Press
settings:
• CHANNEL GUIDE KEY: Sets the default screen that will be
shown when you press the CHANNEL GUIDE button on the
remote control. Select between SMARTGUIDE categories or
CHANNEL LIST screen.
• HIGH DEFINITION: Enables or disables the high definition icon
in the SmartGuide Categories screen.
• SPORTS: Enables or disables the sports icon in the SmartGuide
Categories screen.
• NEWS: Enables or disables the news icon in the SmartGuide
Categories screen.
• KIDS: Enables or disables the kids icon in the SmartGuide
Categories screen.
• MOVIES: Enables or disables the movies icon in the SmartGuide
Categories screen.
• NETWORK: Enables or disables the network icon in the
SmartGuide Categories screen.
• ADULT: Enables or disables the adult icon in the SmartGuide
Categories screen.
• LIFESTYLE: Enables or disables the lifestyle icon in the
SmartGuide Categories screen.
• OTHERS: Enables or disables the others icon in the SmartGuide
Categories screen.
Configure SmartSecure settings
1
Press M on the setup remote control to display the setup menu.
2
Press
SMARTSECURE.
to select CONFIGURATION > SMARTFEATURES
SMARTFEATURES
to select one of the following to configure the
to select CONFIGURATION > SECURITY >
OFF
NO
NO
>
NO
NO
>
EN 7