Philips 26HFL5561L/27 Quick Start Manual page 12

8 Installation of Pay-Per-
View box
This section describes how to install an external pay-per-view box.
Step1: Set the communication mode
You must setup the correct communication protocol before you
connect the Pay-Per-View box to the TV. This section describes how to
select the communication mode.
1
Press M on the setup remote control.
2
to select COMMUNICATION.
Press
COMMUNICATION
COMMUNICATION
STORE
DCM TYPE
CP
3
Press to enter the COMMUNICATION menu.
4
Press to select SP-SPI.
5
Press to select STORE.
6
Press to store your setting.
Step2: Connect the pay-per-view box
Note
•
Turn off your TV before you connect the pay-per-view box.
1
Insert the RJ12 cable of the Pay-Per-View box into the DATA 1
(RJ12) connector of the TV.
2
Connect the other cables as directed by the Pay-Per-View
provider.
3
After completing the connections of the cables, turn on the TV.
4
Press RECALL on the setup remote control and check that the
status of SP-SPI is ONLINE. If the status is OFFLINE, check that
the RJ12 cable and the connections between the terminal and
the TV are correct.
10 EN
SP-SPI
>
NO SOURCE SWITCH
NO
01 32HFL5561D/27 01 32HFL5561D/27
02 SV1A0707100003 02 SV1A0707100003
03 IC7U1 - 0 .11/M3.22 03 IC7U1 - 0 .11/M3.22
04 LC72HUL1 - 0.13 04 LC72HUL1 - 0.13
05 OPT (30) 22 20 1C 23 05 OPT (30) 22 20 1C 23
06 OPT - MODEL 32HFL5561D/27 06 OPT - MODEL 32HFL5561D/27
07 07
08 COMMUNICATION SP - SPI ONLINE 08 COMMUNICATION SP - SPI ONLINE
01 TV2 NOT TUNED 01 TV2 NOT TUNED