Specifications - Central Machinery 43389 Owner's Manual

Specifications

Motor
Spindle Speeds
Spindle
Column
Base Dimensions
Chuck Capacity
Table Slot
Table Rotation
Table Size
Features
Setup - Before Use:
Read the ENTIRE IMpORTANT SAFETy INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO pREVENT SERIOUS INJURy FROM AccIDENTAL OpERATION:
Turn the power Switch of the tool off and unplug the tool from its electrical
outlet before performing any procedure in this section.
Note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
Mounting
Secure the tool to a supporting structure before use.
Before assembly, bolt the Base to a flat, level,
solid floor location capable of supporting the
weight of the drill press and any workpieces.
Assembly
1. Place the column Tube (B14) on the Base,
aligning the mounting holes.
2. Insert four large Machine Screws (B12) into the
mounting holes and tighten with a wrench.
Page 6
120VAC, 60Hz, 13.5A
1720 RPM
200, 290, 350, 430, 500, 580, 640, 720, 800, 870,
1440, 1630, 1820, 2380, 2540, and 3630 RPM
Stroke: 3-1/8"; Taper: MT2
Ø 3.15 (diameter) inches;
Head to base: 50-3/4"
Chuck to base: 45-1/2"
Chuck to table: 25-1/4"
13-1/2" x 20-1/4"
1/8" to 5/8"; Taper: JT3
1/2" x 4"
360°; Tilt: 45° (left and right)
14" x 14"
Oiler with flex-tube, and lamp
Column Tube (B14)
Machine Screws (B12)
For technical questions, please call 1-888-866-5797.
Verify that installation surface has no hidden
utility lines before drilling or driving screws.
3. Install the column clamp (B16) on the left side
of the Table Support (B17). Hand Tighten.
Column Clamp (B16)
Item 43389