Safety Instructions - Danfoss ECtemp Next Plus Installation Manual

Danfoss ECtemp Next Plus
Standard "Automatic electrical controls for household and
similar use":
• EN/IEC 60730-1 (general)
• EN/IEC 60730-2-9 (thermostat)
1�2

Safety Instructions

Make sure the mains supply to the thermostat is turned off
before installation.
Important: When the thermostat is used to control a floor
heating element in connection with a wooden floor or
similar material, always use a floor sensor and never set the
maximum floor temperature to more than 35°C.
Please also note the following:
• The installation of the thermostat must be done by an
authorized and qualified installer according to local
regulations.
• The thermostat must be connected to a power supply
via an all-pole disconnection switch.
• Always connect the thermostat to continuous power
supply.
• Do not expose the thermostat to moisture, water, dust,
and excessive heat.
Installation Guide 5