0312266_INNOVO_UKUK_V3.0, 2017-02-10
After that:
3.
Fill the water heater (see section 8.9.1).
4.
Make sure the air pressure differential is correct, refer to Air pressure differential
(see section 8.9.2).
5.
Make sure the gas supply pressure is correct, refer to Gas supply pressure (see
section 8.9.3).
6.
Make sure the CO2 value is correct, refer to CO
7.
Turn on the water heater (see section 4.2).
8.
Set parameter 211 to rst, refer to Settings (see section 10).
9.
Press [RESET].
The water heater goes to OFF mode.
value (see section 8.9.4).
2
69