Sagem MORPHOACCESS 200 Installation Manual page 63

• 1 : [Light then gabor] (default mode for older versions (<5.2))
Identification will proceed in two steps like described in the previous
paragraph. Light coding, and in case of failure gabor coding.
Some identifications are slower but chances of success are increased.
• 2: [Advanced mode: light coding then gabor on the second try]
(default mode)
In this mode gabor coding is disabled. Like in the [Light only] mode the
answer of the control is immediate.
Unlike the mode [Light only], in case of failure, the gabor coding will be
reactivated for the immediate next control to increase chances of success
for a second try.
After a given time of inactivity or after a second failure the terminal
automatically switches in the [light only] mode. This period may be
modified.
Coding duration
The cfg/Maccess/Bio/advanced timeout parameter allows setting in
seconds the period while the gabor coding will be activated when the
terminal is set in [Advanced mode] mode.
• 0: If the light identification failed, the terminal will be temporarily
switched in the [light then gabor] mode. After this second
identification the terminal is in [light only] mode.
• 1-3600: This value determines (in seconds) how long the terminal
will activate the [light then gabor] mode if no finger is presented on
the sensor. After this period it switches automatically in [light only]
mode.
Default value is 5 seconds.
When the terminal switches in "light only" mode the sensor will briefly
flash.
Recognition mode (light, gabor ...)
/cfg/Maccess/bio./
identification strategy
SK-0000011145-05
FILE : cfg/Maccess
SECTION :bio
advanced timeout: 2
PREV NEXT
SAGEM Défense Sécurité document. Reproduction and disclosure forbidden.
EXIT
0 Light only
1 Light then gabor (default)
EDIT
63