Zanussi ZDF18001XA User Manual page 20

A
B
3
Put the detergent or the tablet in compartment
(A) If the programme has a prewash phase,
put a small quantity of detergent in compart-
ment (B).
Setting and starting a programme
Setting mode
For some settings it is necessary that the ap-
pliance is in setting mode.
Press the on/off button to activate the appli-
ance. The appliance is in setting mode when
all the programme indicators come on and the
display shows 2 horizontal status bars.
If the control panel does not show this condi-
tion, press and hold at the same time
and
setting mode.
Starting a programme without delay start
1. Open the water tap.
2. Press the on/off button to activate the ap-
pliance. Make sure that the appliance is in
setting mode.
3. Press the button of the programme you
want to set.
• The related programme indicator flashes
while all the other programme indicators
go off.
• The display shows the programme dura-
tion.
4. Close the appliance door, the programme
starts.
• The related programme indicator comes
on.
• The programme duration starts to de-
crease with steps of 1 minute
20
4
until the appliance is in
Starting a programme with delay start
1. Set the programme.
2. Press the delay start button again and
again until the display shows the delay time
you want to set (from 1 to 24 hours).
• The delay time comes on in the display.
• The related programme indicator flashes.
3. Close the appliance door, the countdown
starts.
• The countdown decreases with steps of
1 hour.
• The related programme indicator comes
on..
When the countdown is completed, the pro-
gramme starts.
You can set a programme, applicable op-
tions and the delay start also with the ap-
pliance door closed. In this condition, you only
have 3 seconds after each setting before the
appliance starts to operate automatically.
Opening the door while the appliance
operates
If you open the door, the appliance stops.
When you close the door, the appliance con-
tinues from the point of interruption.
Cancelling the delay start while the
countdown operates
When you cancel the delay start, also the pro-
gramme is cancelled.
1. Press and hold at the same time
and
indicators come on and the display shows
2 horizontal status bars.
Cancelling the programme
1. Press and hold at the same time
and
indicators come on and the display shows
2 horizontal status bars.
Make sure that there is detergent in the
detergent dispenser before you start a
new programme.
At the end of the programme
• The display shows 0:00.
until all the programme
until all the programme
www.zanussi.com