Faults Search - Hoover T 185 E/1 User Instructions

FAULTS SEARCH

CAUSE
FAULT
Mains plug not plugged in
1. Does not
function on any
programme
Mains switch not on
No power
Electric circuit fuses
failure
Porthole door open
See cause 1
2. Does not load
water
Inlet tap turned off
Incorrect programme
selected
3. Does not Discharge pipe bent
discharge water
Filter clogged
4. Does not spin The washing machine has not
discharged water
"No spin" setting
(only on some models)
Washing machine not perfectly level
5. Strong
vibrations during
spin
Transport bracket
not removed
Washing load not evenly distributed
If the fault should persist, contact a HOOVERTechnical Assistance Centre. For prompt servicing, give the
model of the washing machine, to be found on the label on the back of the appliance or on the guarantee
certificate.
EN
REMEDY
Insert plug
Turn on mains switch
Check
Check
Close porthole door
Check
Turn on water inlet tap
Re-select programme
Straighten discharge pipe
Inspect filter
Wait a few minutes until the machine
discharges water
Turn the programme dial
onto spin setting
Adjust special feet
Remove transport bracket
Distribute the washing evenly
31 32