5. Attach the RJ-45 connector of the two-way cable to the LAN terminal in the radar sensor.
6. Push cables of the two-way cable into the slits of the gasket inside the radar sensor as below.
7. Push the gasket into the hole at the bottom of the radar sensor, then fasten four pan head
screws to fix the plate to the sensor.
8. Release the stay and close the cover.
Note: When closing the cover, set the gaskets to grooves in the bottom chassis, then tigten bolts.
LAN terminal
BOTTOM
CHASSIS
GROOVE
GASKET
HEX BOLT
10
Power terminal
.
Torque : 9.8 ±0.1 N m