Advertisement
QuickSpecs
Configuration Information - Factory Integrated Models
•
•
HPE Drives
Select one or more drives from Core options-HPE Drives section below:
•
•
•
HPE Flexible LOM Select a FlexibleLOM from Core options-Networking section below,
•
•
•
HPE Networking
Select a standup NIC adapter from Core options-Networking section below,
•
•
•
HPE Storage
Select one or more Storage options from Additional options section below.
Controllers
•
•
•
HPE Rail Kits
Select one type of rail kit from Additional options section below.
•
•
This section may contain FIO options, please see HPE I/O Expansion Options section below.
FIO indicates that this option is only available as a factory installable option.
The components of a storage subsystem (e.g. the drive, the HBA/controller, firmware, and the
server backplane) should operate at the same data transfer rate or the system bandwidth will be
negotiated down to an acceptable level for all components.
Hard drives have either a one year or three year warranty; refer to the specific hard drive
QuickSpecs for details.
The HPE ProLiant Gen9 Smart Storage solutions are equipped with re-designed Small Form
Factor (SFF 2.5 in) and Large Form Factor (LFF 3.5 in) hot plug carriers for HPE Qualified Hard
Drives and Solid State Drives. These new carriers provide status and activity indicators as well as
caution indicators for "Do Not Remove".
Only one FlexibleLOM can be added to the server. These options are upgradeable and can be
changed from the original configuration after the server is shipped.
For 10Gb adapters, a minimum of two Gigabytes (2 GB) of server memory is required per each
adapter.
Please see the QuickSpecs for Technical Specifications and additional
information: http://www.hp.com/go/ProLiantNICs.
Please see the QuickSpecs for Technical Specifications and additional
information: http://www.hp.com/go/ProLiantNICs.
These options are upgradeable and can be changed from the original configuration after the
server is shipped.
For 10Gb adapters, a minimum of two Gigabytes (2 GB) of server memory is required per each
adapter.
The embedded B140i controller will operate in UEFI only mode. For legacy support an additional
controller will be needed, and for CTO orders please also select the Legacy mode settings part,
758959-B22
This section may contain FIO options, please see HPE Storage Controllers section below.
FIO indicates that this option is only available as a factory installable option.
Please take a moment to review the installation documentation that comes with the server to help
you with the installation of your Gen9 server.
To assist in the installation of the server into the rack, an optional installation tool is available by
contacting your local services representative (p/n 695539-001).
HPE ProLiant DL560 Generation9 (Gen9)
Page 20
Advertisement
