Advertisement
QuickSpecs
Standard Features
On System
HPE iLO (Firmware HPE iLO4 2.0 or later) 4GB NAND
Management
NOTE: 1GB USB user space configurable via UEFI and accessible via iLO. Read
Chipset
and learn more in the
Memory
Type:
One of the
HPE SmartMemory
following
DDR4 Registered (RDIMM) or Load Reduced (LRDIMM)
depending on
DIMM Slots Available
model
Maximum Capacity
(LRDIMM)
Maximum Capacity
(RDIMM)
NOTE: HPE memory from previous generation servers are not qualified or warranted
with this HPE ProLiant Server. HPE SmartMemory is required to realize the memory
performance improvements and enhanced functionality listed in this document for
Gen9. For additional information, please see the
NOTE: LRDIMM and RDIMM are distinct memory technologies and cannot be mixed
within a server.
NOTE: Depending on the memory configuration (for instance: number of DIMMs and
DIMMs per channel, type of memory) and processor model, the memory speed may
run at 2400, 2133, 1866MHz, 1600MHz. Please see Memory Population Table below
or the
Memory
Advanced ECC
Protection
Online spare
Mirroring mode
Demand and Patrol
Scrubbing
Failed DIMM Isolation
Data Bus ECC
Protection
Memory Thermal
Control
Memory Mirroring
Inter-Socket
iLO
QuickSpecs.
48
3TB
1.5TB (48 x 32GB RDIMM @2400 MHz)
Online Memory Configuration
Advanced ECC uses single device data correction to detect
and correct single and all multibit error that occurs within a
single DRAM chip.
Memory online spare mode detects a rank that is degrading
and switches operation to the spare rank.
Memory mirroring inter-socket stores a copy of memory with
dynamic failover in case of failure. Once a DIMM in a mirrored
set is detected as failed, the mirror failover uses its mirrored
DIMM.
Memory demand and patrol scrubbing prevent accumulation
of correctable errors and reduces the likelihood of unplanned
downtime.
Failed DIMM isolation improves the service time thus
improving the overall system availability.
Data Bus ECC protection provides automatic correction from
a single data bit error and detection of double data error bits.
Often called single error correction/double error detection
(SEC/DED).
Memory thermal control is used to prevent DIMMs from
overheating. Achieved by slowing down the memory access
rate per the temperature monitored by DIMM sensor.
Memory mirroring inter-socket stores a copy of memory with
dynamic failover in case of failure. Once a DIMM in a mirrored
set is detected as failed, the mirror failover uses its mirrored
DIMM.
DA - 15296 Worldwide QuickSpecs — Version 10 — 6.20.2016
HPE ProLiant DL560 Generation9 (Gen9)
(12 DIMM slots per processor, 4 channels per
processor, 3 DIMMs per channel)
(48 x 64GB LRDIMM @2400MHz)
HPE SmartMemory
Tool.
QuickSpecs.
Page 4
Advertisement
