Removing The Intake Manifold - PIAGGIO MSS X9 Evolution 250 Workshop Manual

Engine
- Insert the free wheel on the flywheel as shown in
the photo
- Then refit the flywheel with free wheel and trans-
mission gear
- Using the special flywheel stop tool, tighten up
the flywheel fixing nut to the prescribed torque
-Refit the retention plate
Specific tooling
020627Y Flywheel lock wrench
Locking torques (N*m)
Flywheel nut
Refitting the starter motor
- Fit a new O-ring on the starter motor and lubricate it.
- Fit the starter on the crankcase, locking the two screws to the prescribed torque.
Locking torques (N*m)
Starter motor screws 11 ÷ 13
Cylinder assy. and timing system

Removing the intake manifold

- Loosen the 3 crews and remove the intake mani-
fold.
ENG - 106
Downloaded from www.Manualslib.com
94 ÷ 102
manuals search engine
MSS X9 Evolution 250