Turning On Power; Understanding The Status Screen - HP photosmart 630 series User Manual

Turning on power

NOTE
You must remove the lens cap to be able to operate the
camera. If you turn on the camera without removing the
lens cap, an error message will display on the Image
Display. See
Remove the lens cap and then turn
on the camera by sliding the
ON/OFF switch to the right and
releasing it.
The lens extends, the Image Display
turns on for a few seconds (see the
next subsection), and the Power/
Memory light turns on solid.

Understanding the status screen

When you turn on the camera, the HP logo screen and then the
status screen display for a few seconds on the Image Display.
The main part of the status screen
shows the current
setting (designated by the stars),
number of pictures remaining,
battery level, and flash setting. Any
non-default Capture
are also shown across the top of the
status screen.
The status screen is also displayed for a few seconds any time
you change the flash settings on the camera. See
flash on page 31.
Chapter 1: Getting started
Messages on the camera
Image Quality
menu settings
on page 87.
Setting the
17