Integra DTR-7.4 Service Manual page 7

PANEL VIEWS
REAR PANEL
DIGITAL IN/OUT
These jacks are for connecting components with
digital input and output capabilities.
PRE OUT
To use the DTR-7.4 as a preamplifier, connect a
power amplifier to this jack.
ANTENNA
These jacks are for connecting the FM indoor
antenna and the AM loop antenna that are supplied
with the DTR-7.4.
ZONE 2 OUT
This jack is for connecting the component that will
be used in the remote zone (Zone 2).
MONITOR OUT VIDEO/S VIDEO
These jacks are for connecting to the video input
jacks on television monitors or projectors.
COMPONENT VIDEO OUTPUT
These jacks are for connecting to the component
video input jacks on television monitors or projectors.
ETHERNET (Net-Tune)
This connector is for connecting to an Ethernet network.
SPEAKERS
These terminals are for connecting the speak ers.
AC OUTLETS
This AC outlet is provided to plug in the power cord
from another component. The shape and number of
the AC outlet depend on the shipping destination.
MULTI CH INPUT
This connector is for connecting components with a
multichannel output.
PHONO/CD/TAPE AUDIO IN/OUT
These connectors are for connecting to the audio
input and output jacks on audio components.
DVD/VIDEO1-4 IN/OUT
These connectors are for connecting to the video
input and output jacks on video components.
COMPONENT VIDEO INPUT1/2
These connectors are for connecting to the compo-
nent video outputs of video components that have
them.
RS 232
This port is for connecting the DTR-7.4 to home
automation and e xternal controllers.
IR IN/OUT
These connectors are for connecting the remote sen-
sor of a multi-room kit (sold separately).
12V TRIGGER OUT ZONE 2 A/B
These connectors are used to connect to the 12V
TRIGGER IN terminal of a component.
This jack is for connecting other Integra/Onk yo
components equipped with the same
The audio connection cables must also be con-
nected.
AC INLET
This connector is for connecting the supplied power
cord.
DTR-7.4
terminal.