Fujitsu primequest 2400E2 Design Manual page 40

2.2.2 Memory (5/7)
• DIMM installation order for each mode (when one of the following conditions apply)
• Dynamic Reconfiguration is used
• One partition is configured with four boards that are a combination of system boards and Memory
Scale-up Boards
• One PPAR block is configured with eight CPUs when the Segment Mode is set as the PCI Address mode
0A0 0A3
Slot
0A1 0A4
No.
0A2 0A5
1 1
Normal
3 3
Mode
5 5
1 1
Mirror
2 2
Mode
3 3
1 1
Spare
1 1
Mode
1 1
• Install DIMMs at the same time in the slots with the same installation order number.
• When Dynamic Reconfiguration is used or one PPAR block is configured with eight CPUs, two CPUs are installed in an SB.
• When only one CPU is installed and Dynamic Reconfiguration is enabled, IOU- Dynamic Reconfiguration requires memory
installation for CPU#0 in the above order.
• DIMMs are available in sets of two.
PRIMEQUEST 2000 Series Design Guide
CPU#0
0B0 0B3 0C0 0C3
0B1 0B4 0C1 0C4
0B2 0B5 0C2 0C5
2 2 1 1
4 4 3 3
6 6 5 5
1 1 1 1
2 2 2 2
3 3 3 3
2 2 1 1
2 2 1 1
2 2 1 1
0D0 0C3 1A0 1A3
0D1 0C4 1A1 1A4
0D2 0C5 1A2 1A5
2 2 1 1
4 4 3 3
6 6 5 5
1 1 1 1
2 2 2 2
3 3 3 3
2 2 1 1
2 2 1 1
2 2 1 1
39
CPU#1
1B0 1B3 1C0 1C3
1B1 1B4 1C1 1C4
1B2 1B5 1C2 1C5
2 2 1 1
4 4 3 3
6 6 5 5
1 1 1 1
2 2 2 2
3 3 3 3
2 2 1 1
2 2 1 1
2 2 1 1
(Slots with the same symbols must have
the same type of DIMM installed.)
Copyright 2016-2017 FUJITSU LIMITED
1D0 1D3
1D1 1D4
1D2 1D5
2 2
4 4
6 6
1 1
2 2
3 3
2 2
2 2
2 2