Apm Configuration; Network Stack Configuration; Hdd/Ssd Smart Information - Asus CROSSHAIR VI HERO User Manual

3.6.5

APM Configuration

The items in this menu allow you to set system wake and sleep settings.
ErP Ready [Disabled]
This item allows you to switch off some power at S4+S5 or S5 to get the system ready for
ErP requirement. When set to [Enabled], all other PME options are switched off.
Configuration options: [Disabled] [Enable(S4+S5)] [Enable(S5)]
Restore On AC Power Loss
This item allows your system to go to ON state, OFF state, or both states after an AC power
loss. When setting your system to [Last State], it goes to the previous state before the AC
power loss.
Configuration options: [Power Off] [Power On] [Last State]
Power On By PCI-E/PCI
This item allows you to enable or disable the Wake-on-LAN function of the onboard LAN
controller or other installed PCI-E LAN cards.
Configuration options: [Disabled] [Enabled]
Power On By RTC
This item allows you to enable or disable the RTC (Real-Time Clock) to generate a wake
event and configure the RTC alarm date. When enabled, you can set the days, hours,
minutes, or seconds to schedule an RTC alarm date.
Configuration options: [Disabled] [Enabled]
3.6.6

Network Stack Configuration

The items in this menu allow you to enable or disable the UEFI network stack
3.6.7

HDD/SSD SMART Information

This menu displays the SMART information of the connected devices.
NVM Express devices do not support SMART information.
3-16
Chapter 3: BIOS Setup