Samsung SRN-473S Quick Manual page 7

Additional camera registration
In the <Install Wizard> setting, make a connection to the camera automatically registered and use the menu
path to register and connect a camera.
Menu Device Camera
Mouse right menu Quick Setup
To register a camera, follow these steps:
Select the camera to register (you can select multiple cameras).
Click <ID/PW> to register your ID and password. (If you do not register a new ID/PW, then the default
ID/PW combination is used.)
Click <Connection Test>.
Check the connection results.
If the channel connected successfully, click <OK> to end the camera registration process.
`
M
Click an item on the table to see a preview (you must change the ID/PW in step
`
Click the table headers to sort the content.
`
Click < > to check if a new IP address was allocated to the camera when you rescan the network or when an IP
address was not assigned by the DHCP server (e.g., 192.168.1.100). If the IP still stays the same, then select Assign IP to
assign the IP manually.
Configuring the Recording
This section outlines how to configure and view the recording settings for each channel.
Shows the standard and event recording method for each channel.
• FULL : Records all the frames received from the camera.
• KEY : Records only the key frames received from the camera. In general, one or two frames per second
are recorded, but you can adjust this in the camera settings.
• OFF : Turns off recording.
Cam Registration Auto
Camera Register
if the camera account changes).
FULL NO
Recording Restriction
Record data size exceeded limitation
Only key frames are recorded
Please check the record settings
Do not show this message again
OK Record Status
English _7