Replacing The Zigzag Width Motor - ELNA eXperience 620 Service Manual

REPLACING THE ZIGZAG WIDTH MOTOR

REPLACING THE ZIGZAG WIDTH MOTOR
TO REMOVE:
1. Remove the front cover (unit) (see page 8).
2. Remove the printed circuit board "A".
3. Remove the two setscrews (B) and remove the zigzag width motor.
TO INSTALL:
4. To install the zigzag width motor, follow the above procedure in reverse.
NOTE: 1. The setscrews (A) should be tightened at 5-7 kg of torque.
2. Check to ensure that the upper shaft sensor mounted on the zigzag width motor does
not interfere with the upper shaft shield plate.
3. Adjust the needle drop position (see page 11).
Setscrews (B)
Setscrews (B)
Zigzag width motor
Setscrews (A)
32
MODEL: eXperience 620
Setscrews (A)