Needle Drop Position Alignment - ELNA eXperience 620 Service Manual

NEEDLE DROP POSITION ALIGNMENT

Select the stitch pattern "
plate hole.
When the needle swings in maximum zigzag width "
needle hole in the needle plate and the needle should be 0.2 mm or more. If not, adjust as follows.
ADJUSTMENT PROCEDURE:
1. Turn on the power switch, select the straight stitch pattern "
" " then check the needle drop position.
2. If the needle drop position is not in the center of the needle plate hole when the straight stitch is
selected, or if the clearance between the needle and edge of the needle plate hole on both side is
less than 0.2 mm when the stitch pattern is set to maximum zigzag width, remove the face cover
and loosen the setscrew, then adjust the needle drop position by turning the eccentric pin.
NOTE: Make sure the eccentric pin is positioned with its off-center head facing downward.
When you have finished adjusting the needle drop position, tighten the setscrew and
attach the face cover.
Setscrew 3x4
Eccentric pin position
(Off center head)
Adjust the needle drop position by turning the eccentric
pin as shown
"; the standard needle drop position should be at the center of the needle
Eccentric pin
11
", the clearance between both ends of the
" and the zigzag width at maximum
Needle plate hole
0.2 mm or
more
MODEL: eXperience 620
0.2 mm or
more
A=B